TW060: Welding Best Practice

Home Course Categories TechnicalTW060: Welding Best Practice

TW060 - Welding Best Practice

Duration: ± 5 days | Course Code: TW060 | Cost From: R 1500 ($ 100)

This course consists of 3 Modules to cover the activities welders need to have knowledge and understanding of in order to work under minimal supervision and to produce acceptable quality work. The subjects covered are:

- - - - Welding Symbols on Drawings
        
        Pre-heat and Post Weld Heat Treatment
        
        Quality Control

Depending on the company, the application and the industry, welders may or may not to be practically proficient in actually carrying out some of these actions, but all should have a good knowledge and understanding of the process their work will undergo. Coded welders should generally be proficient in all of these modules.

In this manner, the welder will appreciate the necessity of following Best Practice principles on every welded joint.

The module consists of 3 videos approx. 10 minutes duration, Course Notes and final Quiz on the theory at the end of each module. There may be a practical test at the discretion of the company/instructor.

Instructors are cautioned to ensure the learners are first exposed to some Safety Training of Gas, heating and Fire – we recommend the Fire Safety Video on this site.

(When watching the video trailers, it is best to start the video and then immediately pause it, then wait a few minutes to allow streaming before starting play again.)

Objectives

dsfasdfasdf

Target Audience

asdfasdf

Learning Outcomes

Instructors need to allow discussion of this theory and have samples prepared for practical demonstrations and verify the welder’s ability to carry out some of these Practices correctly. The duration will vary depending on the instructor’s requirements.

Cost

Access to this course will cost R 1500 ($ 100)
All material is subject to copyright

Practical work and assignments are not included and are for the arrangement and cost of the facility where the practical work is being carried out.
Learners preferably need access to technical drawings for fabrication works, fabrication facilities and equipment.

Note

Discounts are available for groups and/or for complete courses including the welding process selected, and for a combination of each. Alternatively, each module can be purchased separately for those undergoing Inspector and Quality Control Training as opposed to Welding.

Please contact us for more details to meet your requirements.

Duration: ± 5 days

Course Code: TW060

Our Training Partners

A short guide to starting one of our courses...

Select the course you are interested in from the list of courses
View the course to find out: Duration, Cost and Scope
Send an enquiry to find out how to register and start learning online.
Interested in more than one course? Make a note of the reference numbers of each and select the first course as above, and add the references of additional courses in the message block of the enquiry form. We do the rest.

Our Online Courses